SAFE-TECH DS-6101HFI-IP Guía de usuario descargar pdf (Pagina 55)

Page 55

Sensor/Relay

The Sensor/Relay configuration allows you to configure and name the Sensors and Relays

that are attached to the Server. An I/O Alarm Controller (purchased separately) is required

for connecting alarm sensors and relays. A RS-232 to RS-485 converter may be needed to

connect the alarm controller to the PC‟s serial port (RS-232). The system can be configured

to respond to sensor inputs in a variety of ways as described in the Sensor and Cameras |

Alarms sections.

COM Port: Set which COM Port the Alarm Controller is plugged into via the RS-232/485

converter.

Address: Set the RS-485 address for the Alarm Controller.

Sensors: Set the number of Sensors on the Alarm Controller at the COM Port and

Address specified.

Relays: Set the number of Relays on the Alarm Controller at the COM Port and Address

specified.

Enable Device: Check this box to enable the I/O device configured.

Activate Relays: Check this box to activate all Relay actions as defined in Cameras |

Alarms.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 199 200

Sin comentarios

SAFE-TECH DS-6101HFI-IP Guía de usuario Pagina 55